Sponsored by Creative Control Concepts
 | ||||||||
 |
 |
 |
|
 |
|
 |
|
 |
| Home
Automation FAQ Sponsored by Creative Control Concepts |
|
||||||||||||||||||
|
|
 Home Automation FAQ : HA Equipment : Creative Control Concepts/HCS-II : HCS-II Supervisory Controller :
HOST is updating, but I can't update the time or send a new program |
| If you are not using the cable provided with your HCS-II, you must make sure the CTS pin is pulled high on your PC. You can do this by jumpering CTS (Pin 5 on DB25) to DTR (Pin 20 on DB25) on the PC side since DTR goes high when HOST starts. The HCS-II also provides a few pins pulled high though its easier to jumper on the PC side. Also, the HCS-II requires RTS to be connected from the PC to the DX2 (Pin 4 on DB-25s)
| |
 Append to This Answer |
| Previous: |
 I'm having trouble after my upgrade when I put all my stack boards on
|
| Next: |
How can I make a serial cable with a DB-9 connector on it?
|
| ||||||||||